GPR Scanning Leak Detection in Prince Rupert | AnyLeak

A Closer Look at This Service

The cost of finding a leak is small compared to the cost of the damage it causes. A month of undetected leaking can wet insulation, rot framing, wash soil, and attract mould in the time it takes to book an inspection.

Every city in British Columbia presents its own combination of soil, climate, construction stock, and water systems, and detection work has to respect those differences. The plan is built accordingly.

A professional investigation does not end with a verbal summary. It ends with a written report, and that report is the point of the exercise: a document that carries the finding, the evidence, and the guidance to the repair.

How the Investigation Is Delivered

Every investigation follows the same disciplined sequence: consultation, survey, testing, cross-verification, marking, and documentation. The sequence is deliberate, and each step builds on the last.

• Step 1: Consultation to understand the situation and the history
• Step 2: Site survey and indicator mapping
• Step 3: Testing of the suspected systems with matched methods
• Step 4: Cross-verification of the finding
• Step 5: Marking and documentation
• Step 6: Written, dated report

The second most common mistake is repairing the symptom. Patching the drywall, repainting the ceiling, or sealing the visible crack does not stop the water; it hides it. The water finds the next weak point, and the pattern repeats.

What This Costs

The comparison that matters is not detection cost versus no cost; it is detection cost versus the cost of an undetected leak. One targeted repair, guided by an exact location, almost always costs less than exploratory work and repeated damage.

Pricing for this service in British Columbia depends on the scope of the investigation: the systems to be tested, the size of the property, and whether the finding is confirmed with a second method. A fixed quote is provided before any work begins, so there are no surprises on the invoice.

Insurance and Documentation

For BC policyholders, the practical value is speed: the claim starts with the report already in hand, instead of weeks of back-and-forth while the insurer tries to establish what happened.

The report also protects the policyholder. When the cause is documented at the time of the loss, there is no later dispute about what was found, when it was found, or what the condition was.

What the Report Includes

Reports are dated and structured so that any licensed contractor can take the marked location and proceed directly to the repair. They are also accepted by insurers, engineers, property managers, and, when needed, in dispute processes.

You keep the report. It documents the finding, the condition at the time of the investigation, and the guidance for the repair, which is useful for warranty, insurance, and future reference.

When to Call

Call before the damage becomes visible if the meter is moving with everything off. That reading is the earliest and cheapest moment to act, and acting early is what makes the repair small.

Call when a repair contractor cannot find the source. Blind replacement of pipe, membrane, or roofing is expensive, and it fails when the true cause is elsewhere. The investigation answers the question the contractor could not.

How to Prepare the Property

If there is an active leak, the priority is containment: shut off the water at the fixture or main if it can be done safely, move valuables away, and photograph the scene. The technician can be guided by phone while en route.

Clear access to the meter, the main shut-off, the water heater, and the areas showing indicators speeds the investigation. A cleared path saves the technician’s time, which is your time on the quote.

Common Questions

Is this service non-invasive?

Yes. Every method used works from the surface and leaves no marks. Nothing is cut, dug, or permanently marked during the investigation.

How accurate is the location?

With cross-verified methods, locations are typically within a metre or less, and slab locations within inches.

Is the report useful for insurance?

Yes. The report documents the cause, the extent, the methods used, and the readings, structured for claims and engineering review.

How long does an investigation take?

Most property-level investigations complete within a day, and the written report follows within one to two business days.

Do you repair leaks?

No. Detection and documentation are the service. The report guides the repair contractor to the exact location.

What does this cost?

The quote is fixed before work begins, based on the scope defined in the free consultation. What you are quoted is what you pay.

Call (604) 269-5325 or email info@anyleak.ca for a free consultation. The report is dated, documented, and written to the standard insurers and engineers expect.