Direct Answer
AnyLeak provides condo leak inspection services in British Columbia using non-invasive methods — acoustic correlation, tracer gas, thermal imaging, and moisture metering — to find leaks without digging or damage. Every inspection includes a written, insurance-ready report. Call (604) 269-5325 for a free phone consult.
🔄 Reviewed and maintained by the AnyLeak team — October 2026. Rated 5 stars by BC customers.
BC’s coastal buildings are built for rain, not deep cold — so when an arctic outflow arrives, pipes in exterior walls, parkade ceilings and unheated chases are the casualties. The cruel part is the timing: the split happens during the freeze, but the flood arrives at thaw. AnyLeak.ca pinpoints freeze-related leaks and helps stratas harden against the next snap. Since 1999.
Where condos freeze
- Pipes in exterior walls — especially kitchen and bath runs on outside walls; see kitchen leaks.
- Parkade-ceiling lines over open ramps and vents — domestic and sprinkler branches both.
- Hose bibs and irrigation not isolated before winter.
- Suites left cold — thermostats off in vacant units chill shared walls beyond their own walls.
After the thaw
Freeze splits are often multiple — one event, several weak points. We scan the affected zones with thermal imaging, pressure-test by section, and pinpoint each breach with acoustic and tracer methods so all of them are repaired in one mobilization — documented for the claim.
Before the next snap
A pre-winter pass — exposed-run survey, hose-bib isolation verification, vulnerable-zone thermal check — is the cheapest line item in a strata’s year; it slots into a preventive program.
FAQ
Water ran inside a wall during the thaw but stopped — fixed itself? No — the split is still there, waiting for pressure and the next freeze; testing finds it dry-day.
Freeze damage? Call (604) 269-5325 or request an assessment.
A Closer Look at This Service
Water follows gravity, the path of least resistance, and the buried corridor it sits in, which is why the stain you see is almost never directly above the leak. Understanding where water travels is the entire basis of professional detection work.
Local knowledge matters because the same symptom can point to completely different causes in different cities. The interview, the property history, and the site conditions are always weighed together before any instrument is deployed.
The technician works methodically through the checklist, explaining each step as it happens. Questions are welcome at every stage, and the approach is adjusted when the evidence points in a new direction.
How the Investigation Is Delivered
Every investigation follows the same disciplined sequence: consultation, survey, testing, cross-verification, marking, and documentation. The sequence is deliberate, and each step builds on the last.
- Step 1: Consultation to understand the situation and the history
- Step 2: Site survey and indicator mapping
- Step 3: Testing of the suspected systems with matched methods
- Step 4: Cross-verification of the finding
- Step 5: Marking and documentation
- Step 6: Written, dated report
The third mistake is assuming the leak is in the same room as the stain. Water travels along structure for surprising distances, and the visible stain is almost never the source. The investigation traces the path before any repair is planned.
What This Costs
Most property-level investigations in British Columbia are quoted as a fixed fee once the situation is understood. The quote covers the technician’s time, the instruments, the investigation, and the written report.
The comparison that matters is not detection cost versus no cost; it is detection cost versus the cost of an undetected leak. One targeted repair, guided by an exact location, almost always costs less than exploratory work and repeated damage.
Insurance and Documentation
The report produced after a this investigation investigation is written with insurers in mind. It documents the cause, the extent, the methods used, and the readings taken, so the adjuster has everything needed to process the claim.
For BC policyholders, the practical value is speed: the claim starts with the report already in hand, instead of weeks of back-and-forth while the insurer tries to establish what happened.
What the Report Includes
You keep the report. It documents the finding, the condition at the time of the investigation, and the guidance for the repair, which is useful for warranty, insurance, and future reference.
Reports are dated and structured so that any licensed contractor can take the marked location and proceed directly to the repair. They are also accepted by insurers, engineers, property managers, and, when needed, in dispute processes.
When to Call
Call when a repair contractor cannot find the source. Blind replacement of pipe, membrane, or roofing is expensive, and it fails when the true cause is elsewhere. The investigation answers the question the contractor could not.
Call when a decision needs documentation: an insurance claim, a real estate transaction, a strata dispute, or a warranty process. Those decisions run on evidence, and the evidence has to exist before the deadline.
How to Prepare the Property
Clear access to the meter, the main shut-off, the water heater, and the areas showing indicators speeds the investigation. A cleared path saves the technician’s time, which is your time on the quote.
The best preparation is information: when the issue started, what changed around that time, what the weather did, and what has already been tried. That history is often more valuable than any instrument.
Common Questions
Is this service non-invasive?
Yes. Every method used works from the surface and leaves no marks. Nothing is cut, dug, or permanently marked during the investigation.
How accurate is the location?
With cross-verified methods, locations are typically within a metre or less, and slab locations within inches.
Is the report useful for insurance?
Yes. The report documents the cause, the extent, the methods used, and the readings, structured for claims and engineering review.
How long does an investigation take?
Most property-level investigations complete within a day, and the written report follows within one to two business days.
Do you repair leaks?
No. Detection and documentation are the service. The report guides the repair contractor to the exact location.
What does this cost?
The quote is fixed before work begins, based on the scope defined in the free consultation. What you are quoted is what you pay.
Call (604) 269-5325 or email info@anyleak.ca for a free consultation. The report is dated, documented, and written to the standard insurers and engineers expect.
★★★★★
"Our flat roof developed a leak, and Anyleak responded quickly. They completed a temporary repair right away."
Sorin Silivestru
Google Review